Forum Announcement

Collapse
No announcement yet.

G2 Stalling After Driving

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • G2 Stalling After Driving

    I Have A G2 When You Let Off The Gas And Go Get Push The Gas Againg The Cart Will Not Gain Speed It Will Barely Move No Matter How Much Gas You Give It. Any Ideas

  • #2
    It Does Not Matter If You Pull The Choke. It Has A New Air Cleaner New Plug And Fresh Engine. It Has Done The Same Thing Before Rebuild. Could It Be A Voltage Problem Or Coil Problem?

    Comment


    • #3
      When you let off the gas and then press it again, is the engine still running? It is sputtering very bad? By the way, if you didn't already do this make sure your intake setup is completely sealed up no leaks and all gaskets in place, Yamaha's are very sensitive lol
      Regards

      Comment


      • #4
        When You Let Off The Gas It Will Want To Diesel Or Keep Running. I Put At New Air Box And New Carb Spacer. There Should Be No Leeks.

        Comment


        • #5
          It does not sound like a coil or voltage problem. It sounds like your carburetor is dirty
          Regards

          Comment


          • #6
            Thanks I Was Going To Clean The Carb And Fuel Tank Next
            Attached Files

            Comment


            • #7
              try a ground from engine block to neg battery termial

              Comment

              Show More Comments

              Unconfigured Ad Widget

              Collapse

              Unconfigured Ad Widget

              Collapse
              Loading
              X