Does anyone know the preferred piston to cylinder clearance for a rebuild?? (gas g-1 - should all b the same)
piston - cylinder clearance
Collapse
Forum Announcement
Collapse
No announcement yet.
X
-
Posted earlier by Rogggair View PostMax for rebuilding? So what is the preferred spec? .0012-.0014 is what I heard, but that seems a little small for an air cooled engine... thanx MattiRegardsComment
-
Posted earlier by Rogggair View Postyea, just got the piston...had to go .030 over...I've got access to boring & honing equiptment, so it was easy....just looking for the finish hone spec...thanx againRegardsComment
Recent posts in current forum
Collapse
Unconfigured Ad Widget
Collapse
Unconfigured Ad Widget
Collapse
Comment